Skip to content
King Door SpecialistsRequest a visit
Open 24/7(289) 907-1866Call now
Technician in a black cap holding a wrench to a coiled black spring above a paneled door, with a blue cooler behind. — King City
Answering 24/7 in King City

Garage Doors in King CitySafe for everyonewho walks under it.

Call now · open 24/7(289) 907-1866

What's happening right now?

Door stuck open

Safely, right now

  1. Leave the door where it is: forcing it down or pressing the button again can bend it.
  2. Keep the doorway clear of people, pets and vehicles.
  3. Leave the red emergency release alone while the door is up: it can come down hard.
Call (289) 907-1866

Request a visit What the fix involves

Door won't close

Safely, right now

  1. Give the remote a rest: each new try strains the opener and can bend the door.
  2. Keep clear of the doorway, even to move something out of the way. Tell us on the call if you can see anything in the door's path.
  3. Never tape over, bypass or move the little sensors near the floor to force it shut.
Call (289) 907-1866

Request a visit What the fix involves

Spring snapped

Safely, right now

  1. Don't try to lift the door and don't run the opener.
  2. Keep everyone, pets included, and every vehicle away from the door.
  3. If the door is open, leave the red emergency release alone: without the spring it can fall.
Call (289) 907-1866

Request a visit What the fix involves

Car stuck inside

Safely, right now

  1. Never try to push through the door with the car.
  2. Don't pull the release or lift the door if it feels heavy or you heard a bang. That usually means a broken spring.
  3. Plan on leaving the car where it is until the door has been checked.
Call (289) 907-1866

Request a visit What the fix involves

Photo-eyes, the auto-reverse force setting and a balanced door are what stand between a closing door and a child, a pet or a bicycle wheel. On every visit in King City we test all three, correct whatever has drifted, and explain how you can check them yourself between visits.

Request a visit

Same fees day or night · 27 years in business

The fix, explained · King City

What is the door doing?

EmergencyTorsion Spring ReplacementLooking up at the coil above the door, you can see a clean split with a gap of several centimetres between the two halves.

The fix

Torsion spring replacement is really a service on the whole balance system. The spring sits on a shaft that turns in a centre bearing and two end bearings, drives a pair of cable drums, and lifts the door through two steel cables.

Until then

  1. When a spring breaks, the safe approach for the household is to leave the door where it is, keep people and vehicles clear, and avoid running the opener, which can damage the top section, the trolley or the gear drive.

  2. Pull the manual release only when the door is fully closed unless a technician asks otherwise; a door disconnected while partly open can move on its own if the springs are out of balance.

Call (289) 907-1866Request a visit Torsion Spring Replacement

EmergencyOff-Track Garage Door ResetThe morning after a thaw the opener groaned, the door stayed stuck to the icy floor for a second, then lurched up crooked.

The fix

The reason to stop pressing the wall button is that an opener cannot tell a racked door from a heavy one. Each cycle drives the tilted sections harder into the rails, bending hinges, tearing the track from the jamb and stressing the cables that are already out of place.

Until then

  1. Never run the opener on a door that is off its track or hanging crooked; every cycle drives the racked door harder into the rails and can pull the track from the wall or tear a hinge.

  2. Pull the manual release only when the door is fully closed unless a technician asks otherwise; a door disconnected while partly open can move on its own if the springs are out of balance.

Call (289) 907-1866Request a visit Off-Track Garage Door Reset

EmergencyGarage Door Cable ReplacementThe car bumper kissed the door on the way in.

The fix

Two steel cables do the lifting on a sectional garage door. Each runs from a bracket at a bottom corner up to the counterbalance, and the springs pull on the door through them.

Until then

  1. Never run the opener on a door that is off its track or hanging crooked; every cycle drives the racked door harder into the rails and can pull the track from the wall or tear a hinge.

  2. Pull the manual release only when the door is fully closed unless a technician asks otherwise; a door disconnected while partly open can move on its own if the springs are out of balance.

Call (289) 907-1866Request a visit Garage Door Cable Replacement

EmergencyExtension Spring ReplacementOpen the door by hand and it drifts back down on its own, a little at first and then all at once.

The fix

Every extension spring should carry a containment cable, and replacement is the moment to make sure yours do. A containment cable runs through the centre of the spring and is anchored at both ends, to the rear hanger and to the bracket at the front of the track.

Until then

  1. When a spring breaks, the safe approach for the household is to leave the door where it is, keep people and vehicles clear, and avoid running the opener, which can damage the top section, the trolley or the gear drive.

  2. Pull the manual release only when the door is fully closed unless a technician asks otherwise; a door disconnected while partly open can move on its own if the springs are out of balance.

Call (289) 907-1866Request a visit Extension Spring Replacement

Book soonEmergency Release RepairIt is the coldest morning of the year.

The fix

The visit runs in a fixed order. On the phone you describe what the release did, where the door was, and what kind of opener hangs from the ceiling.

Until then

  1. Pull the release with the door fully closed whenever possible, and keep the opening clear as you do.

  2. Lift a door by its handles or the gripping points on the panel face, never at the joint between sections, which closes as the door bends around the track.

Call (289) 907-1866Request a visit Emergency Release Repair

Book soonGarage Door Opener Diagnosis and RepairThe door stops partway up for no reason, or opens fine and then refuses the next time.

The fix

Garage door opener diagnosis is a fault-finding visit with a fixed order of tests. The technician confirms power at the ceiling receptacle, tries each control on its own, checks the safety sensors and their indicator lights, examines the drive train from motor to trolley, and reads any flash code the unit is showing.

Until then

  1. Pull the release with the door fully closed whenever possible, and keep the opening clear as you do.

  2. Never drive a vehicle at a closed door to get out; the door collapses and the stored tension in the counterbalance is released.

Call (289) 907-1866Request a visit Garage Door Opener Diagnosis and Repair

Answering 24/7 in King City

How a visit goes

King Door Specialists

Job ticket · open 24/7

  1. 1 Call

    Let us take a look

    Describe the property, the hardware and what has changed, and the visit starts from what you have seen.

    (289) 907-1866 · open 24/7

  2. 2 Questions

    A short conversation

    Whether you call or send the form, we ask a few questions: door type, opener make if you know it, and what changed. That shapes the visit.

  3. 3 On the way

    In the van

    King City to Clearview Heights, Heritage Park, King City, Ansnorveldt, Lloydtown, Nobleton, Schomberg and Temperanceville.

    • Lift cables
    • End bearing plates
    • Winding bars
    • Centre bearing bracket and bearing
    • Wire gauge and tape measure
  4. 4 Fixed

    The fix and the proof

    Hands-on diagnosis. On arrival we disconnect the opener and lift the door manually. How it feels in the hand tells us more than any label on the motor.

    The fix and the proof. Worn parts come out, new ones go in, and the door runs through several complete cycles with the sensors tested before we call it finished.

Same fees day, night or weekend · on-site assessment preferred

York, Ontario

King City information

Garage Door Manual Lock Repair, New-Construction Garage Door Installation, Full-View Glass Garage Door Installation, Garage Door Opener Diagnosis and Repair, Torsion Spring Replacement, Garage Door Tune-Up, Garage Door Remote and Keypad Programming, Garage Door Roller Replacement, Photo-Eye Sensor Alignment or Replacement and Garage Door Balance Adjustment

Town
King City, York, Ontario
In business
27 years
Hours
Open 24/7 · nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

What the census means at the door

38%

Homes of every age. About 38% of homes in King were built in 1980 or earlier, according to the 2021 Census.

A mixed-age neighbourhood is where retrofits are most common: safety cables added to extension springs, a torsion conversion on an older door, insulated panels replacing a hollow door, or a quieter belt opener under a newly finished room above the garage. Each is a routine job for us.

87%

Mostly houses. Single-detached houses make up about 87% of homes in King (2021 Census).

Households in detached homes often have several remotes, a keypad and a phone app between family members and their cars. We keep all of them programmed to the opener, replace the ones that have failed, and explain how to add a new one when a car changes hands.

Source: Statistics Canada, 2021 Census of Population

Open King City in Google Maps
Two metal hinges on the edge of a white paneled door, with a spare hinge, screws and a drill on a bench. — King City
  • 27years in business
  • 24/7open, every day
  • Same feesday, night or weekend
  • On siteassessment preferred

Ask about a new garage door for your King City home.

For an older door in King City we look for ways to keep it. Original wood doors and extension-spring setups can run for many more years with safety cables, fresh pulleys and a properly set opener. When a door truly is finished, we say so and explain what a replacement would involve, without pushing.

King, Clearview Heights, Heritage Park, Ansnorveldt, Lloydtown, Nobleton, Schomberg and Temperanceville

  • We show, then tell. Worn cables, tired springs and misaligned sensors are pointed out on the door itself, so the explanation makes sense.

  • Clean-up included. Old parts are removed, surfaces wiped and the floor swept before we consider the visit complete.

  • The right repair for your situation. Some doors deserve a full refresh; others need one part. We help you weigh that against how long you plan to keep the door.

Let us take a look: (289) 907-1866

Ask us anything

Advice · (289) 907-1866

Will the tune-up include replacing worn parts?

Small wear items found on the day, such as a roller or a hinge on a middle section, a bottom seal or a few fasteners, can often be replaced during the visit if you agree and the part is on the truck. Larger items, including springs, cables, drums, bottom brackets, a bent track or an opener gear, are written up as separate repairs with their own quote so you can decide with the facts in hand rather than under a raised ladder.

How do I keep the slide bolt from rusting solid again?

Keep the bottom corner it lives in as dry as you can: push slush away from the inside edge of the door through winter and wipe salt off the bar and guide on a mild day. A light silicone film in late autumn sheds meltwater. Work the bolt once a month even if you do not use it, since a bar that moves regularly stays free. Any stiffness is worth a call while it is still a small job.

What lubricant is right for a garage door?

A lubricant made for garage doors, applied lightly to hinge knuckles, roller stems and the springs, following the door maker's own recommendation, since the right product and whether bearings are included varies by manufacturer. General-purpose penetrating oils are thin and wash away, and heavy grease attracts grit. Nothing goes on the track raceway or on a nylon or plastic wheel. The opener's chain or screw rail may take a lithium grease according to its manual, and the manual for your door names what its maker prefers.

What is the difference between torsion and extension springs?

Torsion springs mount on a shaft above the door and twist to store energy, lifting the door through cables and drums. Extension springs run alongside the horizontal tracks and stretch as the door closes, pulling it up through pulleys. Torsion systems tend to lift more evenly, take up less space beside the tracks and are the standard on most modern doors. Both are professional service items because of the energy they hold.

Open 24/7

Request a visit

Ask about a new garage door for your King City home.

Call now · open 24/7(289) 907-1866
  • On-site assessment preferred
  • Same fees day, night or weekend
  • 27 years in business